Champion P7-30 Manual User Manual download pdf (Page 25)

Pulper - Initial Start-up

Pulper Mechanical Adjustments

Stationary cutting block

Rotating cutting blade

Rotating cutting disk

.010 - .015" Minimum clearance

.020 - .060" Maximum clearance

Rotating cutting blade

Stationary cutter block

1. Refer to the illustrations below and check the clearance between the stationary cutter blocks

and rotating cutter blades.

2. Slowly rotate the cutting disk to make sure that the rotating blades do not hit any of the blocks.

3. Using a feeler gauge, adjust each stationary block between a minimum clearance of .010-.015"

and a maximum clearance of .020-.060". A close clearance produces a finer waste cut.

4. In the event that the cutting blades have burrs on the cutting side of the blade, then remove

them with a metal file. File outward toward the cutting block and dress the blade with fine grit

metal oxide sandpaper if necessary.

5. Securely tighten all fasteners and recheck the clearances to ensure that the clearances are

maintained.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 71 72

No comments

Champion P7-30 Manual User Manual Page 25