Champion 46514 Owner's Manual download pdf (Page 17)

Maintenance

Rev 46514-20100202 English 13

Maintenance

The owner/operator is responsible for all

periodic maintenance.

NOTICE

Maintenance, replacement, or repair of the

emission control devices and systems may be

performed by any non-road engine repair

establishment or individual.

WARNING

Never operate a damaged or defective generator.

WARNING

Tampering with the factory set governor will void

your warranty.

WARNING

Improper maintenance will void your warranty.

Complete all scheduled maintenance in a

timely manner. Correct any issue before

operating the generator.

NOTE

For service or parts assistance, contact our help

line at 1-877-338-0999.

Engine Maintenance

To prevent accidental starting, remove and

ground spark plug wire before performing

any service.

Oil

Change oil when the engine is warm. Refer

to the oil specification to select the proper

grade of oil for your operating environment.

1. Remove the oil drain plug with a 12 mm

socket and extension.

2. Allow the oil to drain completely.

3. Replace the drain plug.

4. Remove oil fill cap/dipstick to add oil.

5. Add 0.63 qt (0.6 L) of oil and replace oil

fill cap/dipstick.

6. Dispose of used oil at an approved waste

management facility.

Spark Plug

1. Remove the spark plug cable from the

spark plug.

2. Remove the spark plug.

3. Inspect the electrode on the plug. It

must be clean and not worn to produce

the spark required for ignition.

4. Make certain the spark plug gap is 0.7 -

0.8mm (0.028 - 0.031 in.).

5. Refer to the spark plug recommendation

chart when replacing the plug.

6. Carefully thread the plug into the

engine.

7. Use the spark plug tool to firmly install

the plug.

8. Attach the spark plug wire to the plug.

Air Filter

1. Remove the snap-on cover holding the

air filter to the assembly.

2. Remove the foam element.

3. Wash in liquid detergent and water.

Squeeze thoroughly dry in a clean cloth.

4. Saturate in clean engine oil.

5. Squeeze in a clean, absorbent cloth to

remove all excess oil.

6. Place the filter in the assembly.

7. Reattach the air filter cover and snap in

place.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

Comments to this Manuals

No comments