Champion 46514 Owner's Manual download pdf (Page 12)

Assembly

8 Rev 46514-20100202 English

Assembly

Your generator requires some assembly.

This unit ships from our factory without oil.

It must be properly serviced with fuel and oil

before operation.

If you have any questions regarding the

assembly of your generator, call our help

line at 1-877-338-0999. Please have your

serial number and model number available.

Remove the Generator from

the Shipping Carton

1. Set the shipping carton on a solid, flat

surface.

2. Remove everything from the carton

except the generator.

3. Carefully cut each corner of the box

from top to bottom. Fold each side flat

on the ground to provide a surface area

Install the Spark Arrester

Insert the spark arrester screen into the

muffler outlet. Secure the spark arrester by

placing the cover plate over the end of the

screen, with the lettering facing outward.

Secure the cover plate with the two screws

and lock washers provided with the spark

arrester kit.

Add Engine Oil

CAUTION

DO NOT attempt to crank or start the engine

before it has been properly filled with the

recommended type and amount of oil. Damage

to the generator as a result of failure to follow

these instructions will void your warranty.

1. Place the generator on a flat, level

surface.

2. Remove oil fill cap/dipstick to add oil.

3. Add 0.63 qt (0.6 L) of oil and replace oil

fill cap/dipstick.

4. Check engine oil level daily and add as

needed.

CAUTION

The engine is equipped with a low-oil-shutoff and

the generator will stop when the oil level in the

crankcase falls below the threshold level.

NOTE

Check oil often during the break-in period. Refer

to the Maintenance section for recommended

service intervals.

NOTE

The generator rotor has a sealed, pre-lubricated

ball bearing that requires no additional lubrication

for the life of the bearing.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 29 30

Comments to this Manuals

No comments